The correct usage method of thermal conductive silicone gel

1. Cleaning the surface: Clean the surface of the adhered or coated material, removing rust, dust, oil stains, etc.

2. Glue application: Unscrew the rubber hose cap, first puncture the seal with the tip of the cap, squeeze the glue solution onto the cleaned surface to make it evenly distributed, and then close and fix the adhesive surface.

3. Curing: Placing the coated parts in the air will cause a gradual peeling phenomenon, and any operation should be completed before surface peeling occurs.

 The curing process is a process of curing from the surface to the interior. Within 24 hours (at room temperature and 55% relative humidity), the adhesive will cure to a depth of 2-4mm. If the location is deeper, especially in areas that are not easily exposed to air, the complete curing time will be extended. If the temperature is lower, the curing time will also be extended.

4. Do not move, use, or package components that have been operated properly until they have reached sufficient strength.

5. Storage: Unused glue should be immediately sealed and stored by tightening the cap.

precautions

After the operation is completed, the unused glue should be immediately tightened with a cap and sealed for storage.

 When reusing, if there is a slight crust on the sealing area, it can be removed without affecting normal use.

 During the storage process, there may also be a small amount of solidification at the mouth of the adhesive. After removing it, it can be used normally without affecting the product performance.

This product will release a small amount of by-products during the curing process, which may cause slight irritation to the skin and eyes. It is recommended to use it in a well ventilated area.

 If accidentally in contact with the skin, wipe it clean and then rinse with clean water;

 If it accidentally comes into contact with the eyes, immediately rinse with clean water and go to the hospital for examination.